Phone case insert size checker
Short answer: measure the inside of the back of your clear case in millimetres, enter the width and height below, and the tool subtracts a small clearance so the paper slides in without buckling. Most people should cut their insert about 1 mm smaller than the inside measurement in each direction.
Not sure how to measure? Take three readings across the inside of the back panel on each side and use the smallest one.
Your insert size
- The insert should be a little smaller than the inside of the case, never bigger.
- A clearance of about 1 mm per dimension is a good default; use 0.5 mm if you want it snug.
- Measure the inside of the back panel, not the phone and not the outside of the case.
- Always print at 100%: a printer that shrinks pages by a few percent will make a perfect size too small.
How to use the size checker
- Measure the inside. Take the phone out, lay the case flat and measure across the inside of the back panel in millimetres. Do it in three places and use the smallest number.
- Enter width and height. You can type inches if your ruler is in inches; the tool converts for you.
- Pick a clearance. 1 mm is a good start. If the insert is too tight, use more; if it slides around, use less.
- Read the result. The tool gives the size to cut in mm and inches, plus a check against your phone’s back size.
- Make the insert. The button opens the insert maker with your custom size already entered.
A worked example
Say the inside of your case measures 70.5 mm wide and 146 mm tall. With 1 mm of clearance the insert is 69.5 × 145 mm, which is 2.74 × 5.71 inches. That leaves half a millimetre on each side, enough to slide in without the paper bowing.
| Clearance | Result | Best for |
|---|---|---|
| 0.5 mm | Snug | Cases with very straight walls and thick paper. |
| 1 mm | Recommended | Most cases and plain or photo paper. |
| 1.5 to 2 mm | Loose | Cases with curved or uneven inside walls. |
Common mistakes
- Measuring the outside of the case. The walls and edges add several millimetres.
- Measuring the phone instead. The phone may be bigger than the flat area of the case, because case corners and lips take space.
- Printing with “fit to page”. It shrinks the whole sheet. Use 100%: see how to print at 100%.
- Forgetting the camera window. The checker sizes the sheet; for the camera hole see how to cut it.
Frequently asked questions
How much smaller than the case should an insert be?
About 1 mm smaller in each dimension is a good starting point. Cases vary, so if the paper catches on the walls use more clearance, and if it slides around use less.
Why does the tool compare my numbers with the phone’s size?
The phone has to fit inside the case, so the inside of the case should be close to the phone’s back size. If your numbers are far off, you probably measured the outside, or the wrong part. It is a sanity check, not a rule.
Can I use inches?
Yes. Switch the units to inches. The result is shown in both millimetres and inches.
My case is not on any list. What do I do?
Use this tool with your own measurements and open the insert maker with the custom size. You do not need to pick a phone.
Does it work for tablets and AirPods cases?
Yes, as long as the inside is between 30 and 320 mm wide and between 40 and 420 mm tall. Large tablet inserts may need more than one sheet.
More free tools and guides
- Insert maker: designs, photos, text and drawing in one editor.
- Free phone case template pack: blank true-size PDF, PNG and SVG for 113 devices.
- Photo insert maker and ready-made coloring pages.
- How to print at 100% and the best paper for inserts.
- How to cut the camera hole.
- All free tools.